Hi!
Im a new user of forextester and I can not figure out what I am doing wrong, please help me!
I noticed that I could not place pending orders close enough to the price so I switched to history mode -> data center -> change propoerties and changed the number for spread, min distance to price and swap (long/short) to lower numbers.
The problem is that when I switch back to testing mode the graph does not look as it should. I will show you a picture of how it looks:
Any idea what misstakes I may have done or how I can solve this?
Best regards
Problems with changing symbol properties
-
- Posts: 2
- Joined: Wed Dec 02, 2015 10:20 am
-
- Posts: 1477
- Joined: Mon Apr 01, 2013 3:55 am
Re: Problems with changing symbol properties
Hello
Please open Symbol properties again and set "Digits after point"=4 (if you use free data from Forexite broker).
Then generate ticks again, switch back to Testing Mode and start a new test, this will help.
Please open Symbol properties again and set "Digits after point"=4 (if you use free data from Forexite broker).
Then generate ticks again, switch back to Testing Mode and start a new test, this will help.
-
- Posts: 2
- Joined: Wed Dec 02, 2015 10:20 am
Return to “General Questions about FT”
Who is online
Users browsing this forum: No registered users and 36 guests